Target Group

• Field Techs from Jenbacher or Service Providers who carry out start-ups and commissioning tasks on Jenbacher gas engines and who have completed the Basic Development Program. This training is a prerequisite for becoming a certified Commissioning Engineer.

Theoretical and practical contents

• Preliminary remarks
• Pre-conditions
• Filling fluids and lubricants
• Power supply
• Module control
• Auxiliaries
• Basic setting, parameterising control and monitoring instruments
• Monitoring equipment

Participation in this training course will give you

• a review of the Basic Development Program
• the ability to set up the necessary project specific software before start-up and commissioning
• the knowledge to operate DIA.NE control system on an extended password level (level 15)
• the ability to work through the commissioning checklist (pre-commissioning section)
• the knowledge to adjust and optimize the relevant control circuits at start-up and commissioning
• the ability to carry out, monitor and record the mandatory VDE measurements
• the ability to localize and remedy faults or errors

Comments

• Course duration:
      • 4,5 days - 29 training units of 60 minutes each

• Number of participants:
      • Minimum of 5 and maximum of 8 people

• Languages:
      • German, English
      • Other languages on request or through an interpreter

Prerequisites

• Basic Development Program completed
• Degree in electrical engineering
• We recommend that a laptop is brought to the training
• Participants must bring their own safety boots