Field Techs from Jenbacher or Service Providers who carry out start-ups and commissioning tasks on Jenbacher gas engines. This training is a prerequisite for becoming a certified Commissioning Engineer.
2 , 3 , 4 , 6 , J624
2 , 3 , 4 , 6 , J624
Electrical
5 days
Brief Description
- Level 1 training for commissioning engineers who want to commission Jenbacher gas engine units.
Target Group
- Field Techs from Jenbacher or Service Providers who carry out start-ups and commissioning tasks on Jenbacher gas engines. This training is a prerequisite for becoming a certified Commissioning Engineer.
Theoretical and practical contents
- Preliminary remarks
- Pre-conditions
- Filling fluids and lubricants
- Power supply
- Module control
- Auxiliaries
- Basic setting, parameterising control and monitoring instruments
- Monitoring equipment
Participation in this training course will give you
- the ability to set up the necessary project specific software before start-up and commissioning
- the knowledge to operate DIA.NE control system on an extended password level (level 15)
- the ability to work through the commissioning checklist (pre-commissioning section)
- the knowledge to adjust and optimize the relevant control circuits at start-up and commissioning
- the ability to carry out, monitor and record the mandatory VDE measurements
- the ability to localize and remedy faults or errors
Comments
- Course duration: • 4,5 days - 29 training units of 60 minutes each
- Number of participants: • Minimum of 5 and maximum of 8 people
- Languages: • German, English
• Other languages on request or through an interpreter
Prerequisites
- FTB and FTA training completed
- Degree in electrical engineering
- We recommend that a laptop is brought to the training
- Participants must bring their own safety boots